| When strength-rated safety is a requirement, reach for the DoubleBack Harness from Ruff Wear. This strength-rated belay harness will open up areas that were previously difficult for dogs to access, while providing an increased level of safety, comfort, and convenience. This dog harness has been design for lifting and lowering in exposed areas.
Some of the intended uses for this harness are:
Climbing
Mountaineering
Canyoneering
Belaying
or helping dogs up and down steep and rocky terrian.
This dog harness is available in a Graphite Gray color.
Strength-rated to 2,000lbf or 8.9kN
Four strength-rated, anodized aluminum lace-back buckles
Strength-rated webbing throughout
Strength-rated, adjustable martingale for a customized fit
Strength-rated tie-in point for easy rope attachment
Padded belly support, adjustable frame, and leg loops for steady weight dispersion
Leg loops tuck away for increased mobility during approach
SIZING INFO:
†girth: measurement around widest part of rib cage performance fit: contoured, athletic cut
girth=measurement around widest part of rib cage
PROPER HARNESS FITTING:
|
1. Feed the end of the webbing strap through the front lace-back buckle, pulling tight so the bottom panel is snug against the dog's belly. Take the end of the webbing and lace it back through the buckle. If your webbing is not laced back over the buckle, it is incorrect and not safe or secure. |
2. Repeat process for the rear buckle and strap, making sure to lace back the webbing. Ensure the belly panel is centered under the dog's belly by sliding the panel to the right or left as needed. |
|
3. Adjust the martingale straps to fine-tune the placement of the martingale plate and belly panel. The martingale plate should be centered over the dog's sternum. The belly panel should begin directly behind the dog's front legs so that the rear girth strap fits across the back of the rib cage. |
4. One at a time, wrap the back leg loop behind the dog's back leg and bring the webbing up and around the inside of the leg to meet the lace-back buckle on the hip panel. Feed the webbing through the buckle and then lace the webbing back through the buckle.
|
|
